Equip your vehicle with 1000W of sound amplification with this amplifier that features variable low-pass and high-pass subsonic filters with top-mounted controls for sound customization and a high-density convection heat sink for heat dissipation.
Product Features
Handles up to 1000W RMS continuous power @ 2 ohms or 500W RMS @ 4 ohms
To equip your car stereo system with sonic power.
Variable low-pass and high-pass subsonic filters
With top-mounted controls, along with boost and gain controls and a tuned bass EQ with up to 18dB bass boost at 40Hz, make it easy to customize sound output.
2- and 4-ohm impedance support
Conducts power evenly to keep the speaker at an appropriate level.
25-200Hz frequency response
For faithful low-frequency sound reproduction.
Muting circuit
Cancels noise interference to improve sound quality.
High-density convection heat sink
Dissipates heat for enhanced operation. Optional vinyl skins (not included) let you easily personalize the look of the heat sink.
3 automatic turn-on modes
Including remote, DC offset and signal sense, along with gold-plated, balanced differential RCA level inputs and RCA preamp outputs for compatibility with a variety of car stereo installations.
LED power and protection indicators
Keep you apprised of the amplifier's status.
Product images, including color, may differ from actual product appearance.
What is the RMS an Peak Power of a 2006 Kicker zx1000 class D amplifier.?
I was looking around an found that amp, it said the RMS =1000, an the Peak=2000. But the new 2008 zx1000 only pushes 1000 Peak an 500 RMS, plus twice the price. The 06 is $260 an the 08 is almost $400 so why are the watts different, also which one is better?
read moreWhat is the firing order for a 1986 kawasaki zx1000?
There are two coils on each side with a wire in top and a wire on bottom. How do I know which wire goes where. Ive found to many different things but none about this bike. Does it matter if the top or bottom wire is hooked up to a certain cylinder?
read moreI have an 86 kawasaki zx1000. when i start to go and release the clutch the bike stalls. why is this?
It runs fine if I hold the clutch in a little bit as I ride, but as soon as i release it all the way the bike dies. The diaphrams need to be replaced, and it has air filters on the carbs. Why does it stall?
read moreWhat other forks will fit on a 1986 kawasaki zx1000 besides the originals?
read more
How to install a kicker zx1000.1 to kicker l5 10z?
the kicker l5 10s are in the original kicker box they are going to be 2OHM and should i use a capacitor
read moreI have a KICKER ZX1000.1 mono if i get a 4 ohm sub will it push all 1000 watts?
If i get a 2 ohm will i be able to connect another sub later?
read moreAnyone know where I can find the schematics for a 1986 kawasaki zx1000?
Im putting the engine back in and theres only one wire that I dont know what to do with?
read moreHow much fork oil is needed to fill the forks on a 1986 kawasaki Ninja zx1000?
read more
I have a 1986 kawasaki zx1000. when i try to turn it over the carbs pop off like its firing at the wrong time?
It sounds like it wants to start but it just blows the carbs off. Ive never seen this before. I just had the engine serviced. What could this be?
read moreHow do I adjust the engine timing on a 1986 kawasaki zx1000?
read more
I have a 1986 kawasaki zx1000. My starter is bad. How can i tell if the starter gear is bad.?
Is this ear hard to replace if it is bad? I bought a new starter that im waiting for in the mail.
read moreI just bought a kicker ZX1000.1 what is the best way to connect two kicker CVX subs to the AMP?
im new to this and i just dont know how to hook up two subs to the amp since i just see one channel.. do i have to cross the wire? please help me.... thank you !!!!!
read moreCan a Kicker ZX1000.1 support a Rockford Fosgate P312D4 at 2 ohms? And would I need to upgrade anything?
I have a 2003 chevrolet monte carlo ss with a stock radio.
read moreI have 2 12 inch alpine type R hooked up to a zx1000.1 amp and it doesnt sound good or clean?
Is there a way to hook up the wires to sound better and louder
read moreWhat would be the best way to wire 2 kicker L7 12" to a Kicker zx1000.1 amp?
2 kicker L7 12" (2 ohms) both. one kicker zx1000.1 mono class D amp. how can i wire the subs. thanks.! =]] duel voice coils! 750 rms. kickerss L7. i dont think they make kicker L7 single voice coils!
read moreI have a 1986 zx1000.I just had a new head, base gasket put in. When I try to start it it just back fires.Why?
It wont even start. what is causing this and how do i fix it?
read moreIs it possible to use a 2 ohm sub with the kicker zx1000.1 amp?
Already own a kicker zx1000.1 amp want to purchase a 15" L7 (2000 peak/ 1000rms) want to know if i can use a 2 ohm with this amp or must i run a 4ohm parallel
read morehow can i find out the 1989 kawasaki zx1000 mexico model?
and where can i get the right bottom fairing and the fairing thart goes under neith and front folks for it thr reason y i ask is coz there were only a few made and nobody in nz got no parts and they were for a sasific use in other words its a rear bike
read moreWill the front calipers off a 1986 Kawasaki zx1000 fit on a 1985 zx900 fork?
I need new forks
read moreI have 2 alpine type r 4 ohm 10 inch subs what amp will pound the vehicle? Is the kicker zx1000.1 a good suit?
Also saw a lanzer vibe 286. The subs will be installed in a bassworks vented box. Thank you
read more

Infinity - 342W
$179.99

Kenwood - 1000W
$102.55

Clarion - 360W
$151.95

Kicker - ZX
$269.99

Alpine - 200W
$123.50

Pioneer - 800W
$215.99